Furniture design software Design Sintez

Faience - terracotta

The module is intended for generating of planes of singly floor and wall tiles accord to a schema, combinated with calculating of their quadrature.

General parameters:

You can generated wall and floor tiles. The size of the area that must be covered is defined by the room's sizes, but the length may be set also with pointing the first and the last point in the work screen (press the button Determination of the length by specifying points in the drawing and with left mouse button specify two end points). Press Create. You can enter manually the measures of the area and to choose the position of the plane in the drawing. At the lower right corner in the dialog there is shown the entire quadrature and the number of the tiles that are necessary. You ought to know that the calculated quadrature doesn't include the gaps.
The generated combinations can be edited by module Unit correction.

Height from floor level - The value in the field defines the position of the generated combination toward the premise floor.

Save as unit - Saves the created element as an unit for using it in the current drawing and only for this one. The generated units have nomenclature identifier TF. If you will use the generated element in constructing a new unit in New Base, you can remove the checking.

Schema 1 - Reiteration of tile's model

Enter the sizes of the single tile, the gap width and press the button Create. If you didn't use the button Determination of the lenght by pointing in the drawing, specify the unit insertion point in the working screen.

Schemas 2 and 3 - They are identical. The difference here is that in the second variant the arrangement becomes from below upwards on height and in the third variant - from the left to the right. You can set the arrangement of three different tiles types in different areas of one and the same wall.

The way of work is : Enter the tiles measures for first, second and third area. Enter the value for the height (respectively- length for schema 3) for the first area. The measures are in cm. Go to the field for height (respectively - length) for the third (residual) area. Its measure will enters automatically , based on the common size and the entered values for first and second area. At last press the button Create.

To create an arrangement from two areas, regardless you have chosen vertical or horizontal allocation, don't enter length and height for second area.

Single row tiles in the area - The option sets the generating of the single row of tiles in the second area. If it is not checked, will be created an area with some tiles rows on length or height.

Schema 4- Chess-board order of tiles with two different designs and equal sizes.

Enter the sizes for the single tile, the gap width and press the button Create. If you don't use the button Determination of the lenght by pointing in the drawing, specify the insertion point of the unit in the working screen .

The button Tiles sizes opens a window. Here you can enter frequently used sizes of tiles and load them when this is necessary. This expedite work when you use the same sizes frequently . The list can be sorted by the two sizes: on X and on Y in ascending order.

If you want to add new sizes,enter them into the field and press Add. The choice of already saved makes by the button Select or double clicking with the left mouse button on the row. For exit from the form press Close.

Main page DS User guide